Especificaciones fabricación
De Proyecto Butiá
Revisión del 19:58 25 ene 2014 de Andres (Discusión | contribuciones)
Placa USB4Butiá
Component | Quantity | Description | PCB Identifier |
---|---|---|---|
PIC 18F4550 | 1 | microcontroller | PIC18F4550 |
Socket 40pin | 1 | socket for the microcontroller | |
RJ45 Female Jack | 6 | 5555167-1 type | RJ45 |
USB Female Type B | 1 | USB_B | |
ax12 female bus connector | 1 | molex WM18901-ND connector type | AX-12 |
120R | 1 | resistor | 120Ω |
390R | 2 | resistor | 390Ω |
1K | 2 | resistor | 1KΩ |
10K | 8 | resistor | 10KΩ |
1M | 1 | resistor | 1MΩ |
22PF | 2 | capacitor | 22pF |
0.1UF | 4 | capacitor | 0.1uF |
0.47UF | 1 | capacitor | 0.47uF |
electrolitic capacitor 10UF, 25V, 20% | 1 | lower than 7mm | 10uF |
Led 3mm | 1 | LED | |
20MHZ crystal | 1 | height 0.138" (3.50mm) | Crystal 20MHZ |
4.3mm switch | 2 | RST SW1, PROG SW2 | |
Female Header | 11 | h1..h11 |
Shield para motores
Component | Quantity | Description | PCB Identifier |
---|---|---|---|
L298HN | 1 | HBridge | U1 L298 |
1A7 | 8 | diode | D1..D8 |
male headers | 14 | pin | P1..P4 |
100nF (10V minimum, 20% tolerance) | 2 | ceramic capacitor | C1, C2 |
USB4Butiá motor shield Gerber file
Placa Sensores
Component | Quantity | Description | PCB Identifier |
---|---|---|---|
Rj45 female jack | 5 | 5555167-1 type | RJ45 |
470uf electronic capacitor | 1 | 25V | C1 CAPAPOL |
Resistor 10kΩ | 4 | 5% tolerance, 1/4w power | |
Resistor 6.8kΩ | 1 | 5% tolerance, 1/4w power | |
Resistor 120Ω | 2 | 5% tolerance, 1/4w power | |
Resistor 1kΩ | 2 | 5% tolerance, 1/4w power | |
Resistor 68kΩ | 2 | 5% tolerance, 1/4w power | |
Led | 2 | high intensity green led like 365-1174-ND | LED |
Photoresistor | 3 | 10K-200K OHM 4.20MM LXD4548 | LDR |
GP2Y0A21YK0F | 1 | Sharp Sensor 10-80cm | sharp |
Pushbutton | 1 | KS-03Q-02 | SW_PUSH |
Pushbutton cap | 1 | ACC-C17-6 |
each module specified in plantilla_allsenV2_lasercut-F_SilkS must be cuted with mouse bite technique or similar