Diferencia entre revisiones de «Especificaciones fabricación»

Revisión del 19:57 25 ene 2014

**Bill of Materials USB4Butiá**
Component	Quantity	Description	PCB Identifier
PIC 18F4550	1	microcontroller	PIC18F4550
Socket 40pin	1	socket for the microcontroller
RJ45 Female Jack	6	5555167-1 type	RJ45
USB Female Type B	1		USB_B
ax12 female bus connector	1	molex WM18901-ND connector type	AX-12
120R	1	resistor	120Ω
390R	2	resistor	390Ω
1K	2	resistor	1KΩ
10K	8	resistor	10KΩ
1M	1	resistor	1MΩ
22PF	2	capacitor	22pF
0.1UF	4	capacitor	0.1uF
0.47UF	1	capacitor	0.47uF
electrolitic capacitor 10UF, 25V, 20%	1	lower than 7mm	10uF
Led 3mm	1		LED
20MHZ crystal	1	height 0.138" (3.50mm)	Crystal 20MHZ
4.3mm switch	2		RST SW1, PROG SW2
Female Header	11		h1..h11

**Bill of materials for USB4Butiá motor shield**
Component	Quantity	Description	PCB Identifier
L298HN	1	HBridge	U1 L298
1A7	8	diode	D1..D8
male headers	14	pin	P1..P4
100nF (10V minimum, 20% tolerance)	2	ceramic capacitor	C1, C2

**Bill of Materials allselasercut**
Component	Quantity	Description	PCB Identifier
Rj45 female jack	5	5555167-1 type	RJ45
470uf electronic capacitor	1	25V	C1 CAPAPOL
Resistor 10kΩ	4	5% tolerance, 1/4w power
Resistor 6.8kΩ	1	5% tolerance, 1/4w power
Resistor 120Ω	2	5% tolerance, 1/4w power
Resistor 1kΩ	2	5% tolerance, 1/4w power
Resistor 68kΩ	2	5% tolerance, 1/4w power
Led	2	high intensity green led like 365-1174-ND	LED
Photoresistor	3	10K-200K OHM 4.20MM LXD4548	LDR
GP2Y0A21YK0F	1	Sharp Sensor 10-80cm	sharp
Pushbutton	1	KS-03Q-02	SW_PUSH
Pushbutton cap	1	ACC-C17-6

each module specified in plantilla_allsenV2_lasercut-F_SilkS must be cuted with mouse bite technique or similar

@@ Línea 46: / Línea 46: @@
 |}
-[http://www.fing.edu.uy/inco/proyectos/butia/files/PCBenero2014/usb4butia1.9.0.tar.gz USB4Butiá Gerber file]
+[http://www.fing.edu.uy/inco/proyectos/butia/files/PCBenero2014/usb4butia1.9.0.zip USB4Butiá Gerber file]
 == Shield para motores ==